plane till v0

bdhaMar 14, 2026


After a year of woodworking, I had acquired a lot of hand planes. Arguably too many.

I needed somewhere to store them. Like Saw Till v0, a Plane Till made the most sense. Again, there are lots of ways to do this, but my overriding philosophy in the shop is I need something, I should be able to just grab it off the wall. So I wanted a relatively simple wall-mounted till. I didn't want a complicated cleat system, but obviously they should not just be sliding off on the ground. Planes don't like falling on the floor. I would aim for a board at 70 degrees, with 1/2" dividers.

This project took a long time, and by the end of it I was pretty sick of it and wanted to move on. There were (effectively) two aborted attempts, and the final one is okay, but is full of compromises. That said, it works, and hasn't fallen off the wall yet.03

Never miss a post

Get new writing sent to your inbox.

Subscribe